![]() This development Angle is used to layout cone fabrication layout markings or Flat Pattern Markings. Development Angle (θ) :ĭevelopment Angle has calculated by this calculator and Denoted By θ. Refer to Standard Image for understanding these dimensions at Output sections. This development Radius is used to layout cone fabrication layout markings or Flat Pattern Markings. Development Radius (R1 and R2) :ĭevelopment Radius has calculated this calculator and Denoted By R1 and R2 for Inner and Outer Radius respectively. We always recommend users give this value in multiples of four such as 12, 24, 36, 48, 72, 96, etc. of development lines play a very important role in the accuracy of the layout so optimum no of development lines are needed to select. It is required to give this input while layouting Eccentric Cone. of equal division lines for flat pattern layout marking. of Development lines are a very important input field in this calculator. Refer to Standard Image for Toricone with Knuckle radius at Large End and Knuckle radius at Both Ends. Knuckle radius at Large end normally denoted by R and Knuckle Radius at Small end is denoted by r. Knuckle Radius is the dimension required for flat pattern layouting of Toricone. Refer to Standard Image for Multilevel cones. this types of the cone are required when the large cone is fabricated and it is not possible to layout the cone in a single part due to limitations of raw material sizes or limitations of forming process. It is the process of converting the whole cone into an equal no. of Levels are important dimensions while layouting Multi-Level Cones. Cone Angle (α) :Ĭone Angle is included half-angle of the cone. it is required for the cone fabrication layout or flat Pattern layout development. ![]() Cone Height (H) :Ĭone Height is the Distance between the Large end and small end vertically. Refer Standard Image for Large Diameter d. This calculator accepts metric dimensions so please enter your value in mm. But if you are directly marking layout on cone then use outside diameter. If you are planning to Mark the layout on a Flat Plate Then use the Mean Diameter of the Cone that is nothing but Inside Diameter plus thickness or Outside Diameter minus thickness for higher accuracy. Cone Small Diameter (d) :Ĭone small Diameter (D) is the Diameter of Concentric Cone or Eccentric Cone r Tori Cone at small End. Refer Standard Image for Large Diameter D. Cone Large Diameter (D) is the Diameter of Concentric Cone or Eccentric Cone r Tori Cone at Large End. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |